Guide change config to download original drive file in tools: GPhoto, Okru, Fembed, Openload, Streamango, RapidVideo, Vidcloud

After setup one of above tools then on VPS will have a folder /root/dlcode, config file of module download will be at /root/dlcode/dl.config.json If you want change config to download original drive file then let open/root/dlcode/dl.config.json and find word “filterQualities” then set value 2048p to value of that field, result will be like below image…

Configuring ip6 in gphoto tool

It takes 2 steps to configure IPv6 in the gphoto tool as follows Step 1: Retrieve ipv6 of vps installed tool Step 2: Put IPv6 in the tool configuration file and delete the cache Details as below Step 1: Retrieve ipv6 of vps installed tool To get the ipv6 of vps, type the command below…

How to download videos from openload, streamango, fembed, rapidvideo, okru to VanLong Stream’s tools

You need to take the following 2 steps to download the video from the above hosts, then you have to do the following 2 steps Step 1: Get the link mp4 remote of the hosts on its embed link via the corresponding api Fembed: http://ip:6789/fembed/getLinkStream?linkEmbed= Openload: http://ip:6789/openload/getLinkDownload?linkEmbed= Streamango: http://ip:6789/streamango/getLinkDownload?linkEmbed= RapidVideohttp://ip:6789/rapid/getLinkDownload?linkEmbed= Okru: http://ip:6789/okru/getLinkDownload?linkEmbed= Step 2: Insert…

How to delete cache Added Files in the tools of Van Long Stream

When the number of files or ids added to the tool is too much, it makes it difficult to observe the status of the files that have been processed or has failed. During using the tool, some client said that the driveId was added without converted, but did not know why because the number of…

How to change the number of clones file in gphoto tool

To change the number of clones of a file in the google photo tool, follow the steps below Step 1: Change the value of NUMBER_OF_FILES_ON_GPHOTO in the file /root/gphoto/gphoto.config.json to the number of clone values that you want Step 2: Change the value MAX_CLONE_OF_FILE in the file /root/dlcode/dl.config.json to the number of clones as in…